Mazda 6 Service Manual: Trunk lid

Transmitter battery inspection

Caution Since the battery voltage does not drop fully if the button is pushed for only 4 seconds or less, it can not be properly examined to see whether it is good or bad. Always push the bu ...

Trunk lid removal/installation

Warning Removing the stay damper without supporting the trunk lid can be dangerous. The trunk lid may fall and injure you. Open the trunk lid fully and support it before removing the stay da ...

Other materials:

Mazda 6 Service Manual: Power window main switch inspection
Drivers side 1. Remove the driver-side front door trim. 2. Connect the power window main switch connector. 3. Measure the voltage at the power window main switch terminals as indicated below. 4. Disconnect the power window main switch connector before inspecting for continuity at terminals 1 ...

Mazda 6 Service Manual: Engine coolant temperature (ect) sensor removal/installation
Warning When the engine is hot, it can badly burn. Turn off the engine and wait until it is cool before removing the ECT sensor. 1. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.) 2. Disconnect the ECT sensor connector. 3. Remove the ECT sensor. 4. Install in the reve ...