Mazda 6 manuals

Mazda 6 Service Manual: Trunk lid disassembly/assembly

Mazda 6 Service Manual / Body / Trunk lid / Trunk lid disassembly/assembly

1. Disconnect the negative battery cable.

2. Remove the trunk lid trim.

3. To remove the trunk lid outer handle and trunk lid key cylinder, remove the rear finisher.

4. Disassemble in the order indicated in the table.

5. Assemble in the reverse order of disassembly.



Trunk lid removal/installation
Warning Removing the stay damper without supporting the trunk lid can be dangerous. The trunk lid may fall and injure you. Open the trunk lid fully and support it before removing the stay da ...

Trunk lid adjustment
1. Measure the gap and height between the front door and the body. 2. If not as specified, loosen the door hinge installation bolts or the door lock striker installation screws, and reposition the ...

Other materials:

Mazda 6 Service Manual: General procedures
PRECAUTION (BRAKES) Wheels and Tires Removal/Installation 1. The removal and installation procedures for the wheels and tires are not mentioned in this section. When a wheel is removed, tighten it to 88-118 N·m {9.0-12.0 kgf·m, 65.0-87.0 ft·lbf}. Brake Lines Disconnection/Connection Cautio ...

Mazda 6 Service Manual: Fuel injector removal/installation
Caution Disconnecting/connecting the quick release connector without cleaning it may possibly cause damage to the fuel pipe and quick release connector. Always clean the quick release connector joint area before disconnecting/connecting using a cloth or soft brush, and make sure that it ...

© 2016-2026 Copyright www.mazda6info.net