Mazda 6 Owners Manual: Wrench Indicator Light (Some models)
When the ignition is switched ON, the wrench indicator light turns on and then turns off after a few seconds.
The wrench indicator light turns on under the following conditions:
- When the preset maintenance period has arrived.
- When its time to replace the engine oil.
Refer to Maintenance Monitor.
Indication/Indicator Lights
These lights turn on or flash to notify the user of the system operation status
or a system malfunction.
*Some models.
*1 The light turns on when the ignition is switched on for an operation ...
Low Engine Coolant Temperature Indicator Light (Blue) (Some models)
The light illuminates continuously when the engine coolant temperature is low
and turns off after the engine is warm.
...
Other materials:
Mazda 6 Owners Manual: Removal/Installation
To remove the head restraint, pull it up while pressing the stop-catch.
To install the head restraint, insert the legs into the holes while pressing
the stop-catch.
WARNING
Always drive with the head restraints installed when seats are being used
and make sure they are properly installed: Dri ...
Mazda 6 Owners Manual: No.9 noise while operating a/c system
Diagnostic procedure
* : If there is gas leakage, air enters into the A/C system. The desiccant
within the receiver/drier absorbs the moisture from the air and becomes
saturated. If the A/C system is used in this condition, the inside of the A/C
compressor will begin to rust due to this ...