Emergency Engine Stop
Meters and GaugesMazda 6 Owners Manual: Clutch disc inspection
1. Using vernier calipers, measure the thickness of the lining at a rivet
head on both sides.
Replace the clutch disc if its thickness is less than the minimum.
Thickness
0.3 mm {0.012 in} min.
2. Measure the clutch disc runout using a dial indicator.
If the runout is excessiv ...
Mazda 6 Owners Manual: Heated oxygen sensor (ho2s) inspection
HO2S Voltage Inspection
Note
Perform the following inspection only when directed.
1. Warm up the engine and run it at idle.
2. Disconnect the HO2S connector.
3. Connect the voltmeter test leads to the following HO2S terminals:
HO2S (front and rear)
- (+) leadterminal A
- (-) le ...