Mazda 6 Owners Manual: Aluminum Wheel Maintenance
A protective coating is provided over the aluminum wheels. Special care is needed to protect this coating.
CAUTION
Do not use any detergent other than mild detergent. Before using any detergent, verify the ingredients. Otherwise, the product could discolor or stain the aluminum wheels.
NOTE
- Do not use a wire brush or any abrasive cleaner, polishing compound, or solvent on aluminum wheels. They may damage the coating.
- Always use a sponge or soft cloth to clean the wheels. Rinse the wheels thoroughly with lukewarm or cold water. Also, be sure to clean the wheels after driving on dusty or salted roads to help prevent corrosion.
- Avoid washing your vehicle in an automatic car wash that uses highspeed or hard brushes.
Underbody Maintenance
Road chemicals and salt used for ice and snow removal and solvents used for dust
control may collect on the underbody. If not removed, they will speed up rusting
and deterioration of such underbod ...
Plastic Part Maintenance
When cleaning the plastic lenses of the lights, do not use gasoline, kerosene,
rectified spirit, paint, thinner, highly acidic detergents, or strongly alkaline
detergents. Otherwise, these ch ...
Other materials:
Mazda 6 Owners Manual: Power Moonroof Reset Procedure
If the battery is disconnected, the moonroof will not operate. The moonroof will
not operate correctly until it is reset.
Carry out the following procedure to reset the moonroof and resume operation:
1. Switch the ignition ON.
2. Press the tilt switch, to partially tilt open the rear of the moo ...
Mazda 6 Owners Manual: Clutch fluid replacement
Caution
Be careful not to spill clutch fluid on a painted surface. If this
should happen, wash it off immediately.
Note
Do not mix different brands of clutch fluid.
Do not reuse the clutch fluid that was drained out.
1. Remove the under cover.
2. Draw the fluid from the reservoir ...