Mazda 6 manuals

Mazda 6 Service Manual: Automatic transaxle fluid (atf) replacement

Mazda 6 Service Manual / Automatic transaxle / Automatic transaxle / Automatic transaxle fluid (atf) replacement

Warning

1. Remove the oil dipstick.

2. Remove the oil drain plug and washer.


3. Drain the ATF into a container.

4. Install a new washer and the drain plug.

Tightening torque 30-41 N·m {3.0-4.2 kgf·m, 22-30 ft·lbf}

5. Add the specified ATF until ATF level reaches lower notch of dipstick type of ATF through the oil filler tube.

ATF type
ATF M-V

6. Ensure that the ATF level is in the HOT range (65 °C{149 °F}).

Automatic transaxle fluid (atf) inspection
Automatic Transaxle Fluid (ATF) Condition Inspection One way of determining whether the transaxle should be disassembled is by noting: If the ATF is muddy or varnished. If the ATF smells stra ...

Hold switch inspection
Operating Inspection 1. Turn the ignition switch to ON (engine OFF). 2. Verify that the HOLD indicator light is not illuminated. Depress the HOLD switch and verify that the HOLD indicator light il ...

Other materials:

Mazda 6 Service Manual: Sunvisors
When you need a sunvisor, lower it for use in front or swing it to the side. Side Extension Sunvisors (Some models) The visor extender extends the sunvisor's range of sun shading. To use, pull it out. CAUTION When moving the sunvisor, retract the visor extender to its original position. O ...

Mazda 6 Service Manual: Dtc clearing procedure
1. Start the on-board diagnostic test mode. 2. First press the POWER button, then simultaneously press AUDIO CONT button for 2 seconds or more. Caution Before clearing the DTCs, be sure to enter all of them displayed in the on-board diagnostic test mode in the Audio Repair Order Form. ...

© 2016-2026 Copyright www.mazda6info.net