Mazda 6 manuals

Mazda 6 Service Manual: Base installation

1. Cut away all of the original sealant using a razor.

2. Clean and degrease the ceramic coating on the glass and the base.

3. Apply primer to the bonding area of the glass and the base.

Caution

4. Apply a height of 3.0 mm {0.12 in}

sealant to the base.


Note

5. Center the base in the ceramic coating and press it onto the glass.


6. Use isopropyl alcohol to remove any excess repair sealant.

Hardening time of sealant


7. Install the rearview mirror.

Base removal
1. Remove the rearview mirror. 2. Wind each end of a wire around a bar. Warning Using a SST (piano wire) with bare hands can cause injury. Always wear gloves when using a SST (piano wire). ...

Rear window defroster
...

Other materials:

Mazda 6 Service Manual: Front door removal/installation
1. Disconnect the negative battery cable. 2. To remove the front door hinge, remove the front fender panel. 3. To remove the checker, remove the door speaker. 4. Remove in the order indicated in the table. 5. Install in the reverse order of removal. 6. Adjust the front door. (See DOOR ADJUS ...

Mazda 6 Service Manual: How to use AUX mode
1. Select the icon on the home screen to display the Entertainment screen. 2. Select to switch to the AUX mode. The following icons are displayed in the lower part of the center display. NOTE If a device is not connected to the auxiliary jack, the mode does not switch to the AUX mod ...

© 2016-2026 Copyright www.mazda6info.net