Mazda 6 Service Manual: Rear window defroster

Base installation

1. Cut away all of the original sealant using a razor. 2. Clean and degrease the ceramic coating on the glass and the base. 3. Apply primer to the bonding area of the glass and the base. Caution ...

Filament repair

1. Use isopropyl alcohol to clean around the damaged section of the filament. 2. Attach tape above and below the damaged section of the filament. 3. Using a small brush or marking pen, repair the ...

Other materials:

Mazda 6 Service Manual: Door adjustment
1. Measure the gap and height between the front or rear door and the body. 2. If not as specified, loosen the front or rear door hinge installation bolts or the door lock striker installation screws, and reposition the door. Clearance a: 2.5-4.5 mm {0.10-0.18 in} b: -0.8-1.2 mm {-0.03-0.0 ...

Mazda 6 Service Manual: Selector cable adjustment
1. Remove the center console. 2. Shift the selector lever to P position. 3. Unlock the lock piece of the selector cable (selector lever side) in the order shown in the figure. 4. Verify that the manual shaft is in P position. 5. Lock the lock piece of the selector cable (selector lever side) ...