Mazda 6 Service Manual: Blower unit disassembly/assembly
1. Disassemble in the order indicated in the table.
Caution
- Apply only the specified grease to the link. Otherwise abnormal noise or improper operation may result.
2. Assemble in the reverse order of disassembly.
Blower unit removal/installation
1. Disconnect the negative battery cable.
2. Remove the dashboard. (See DASHBOARD REMOVAL/INSTALLATION.)
3. Remove the A/C unit. (See A/C UNIT REMOVAL/INSTALLATION.)
4. Remove the blower unit.
5 ...
Air filter removal/installation
1. Remove the glove compartment.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal. ...
Other materials:
Mazda 6 Service Manual: Heated oxygen sensor (ho2s) inspection
HO2S Voltage Inspection
Note
Perform the following inspection only when directed.
1. Warm up the engine and run it at idle.
2. Disconnect the HO2S connector.
3. Connect the voltmeter test leads to the following HO2S terminals:
HO2S (front and rear)
- (+) leadterminal A
- (-) le ...
Mazda 6 Service Manual: Pcm removal/installation
Note
For replace the PCM, Setup the WDS and perform the PCM
configuration. (See PCM CONFIGURATION.)
1. Disconnect the negative battery cable.
2. For R.H.D, perform the following procedures.
(1) Remove the front side trim (left-side).
(2) Partially peel back the flower covering.
3 ...