Mazda 6 Service Manual: Cleaning of parts

Mazda 6 Service Manual / General information / Fundamental procedures / Cleaning of parts

All parts to be reused should be carefully and thoroughly cleaned in the appropriate method.

Warning

Using compressed air can cause dirt and other particles to fly out causing injury to the eyes. Wear protective eye wear whenever using compressed air.

Arrangement of parts

All disassembled parts should be carefully arranged for reassembly. Be sure to separate or otherwise identify the parts to be replaced from those that will be reused. ...

Reassembly

Standard values, such as torques and certain adjustments, must be strictly observed in the reassembly of all parts. If removed, these parts should be replaced with new ones: - ...

Other materials:

Mazda 6 Service Manual: Service cautions
HANDLING INSUFFICIENT REFRIGERANT LEVEL If an insufficient refrigerant level is detected at troubleshooting, do not charge (add) the refrigerant. Because an accurate amount of refrigerant cannot be determined from the pressure indicated on the manifold gauge, never charge the refrigeran ...

Mazda 6 Service Manual: Power window main switch inspection
Drivers side 1. Remove the driver-side front door trim. 2. Connect the power window main switch connector. 3. Measure the voltage at the power window main switch terminals as indicated below. 4. Disconnect the power window main switch connector before inspecting for continuity at terminals 1 ...