Mazda 6 Service Manual: Climate control unit inspection
Full-auto Air Conditioner
1. Connect the all center panel connectors.
2. Turn the ignition switch to ON position.
3. Measure the voltage at each climate control unit terminal and refer to the terminal voltage list.
- If not as specified, inspect the parts listed under Action and the related wiring harness.
- If there is any malfunction, replace the climate control unit.
Terminal Voltage List (Reference)
Climate control unit wire adjustment
Air Mix Wire
1. Set the temperature control dial at max cold.
2. Set the air mix link to max cold in the direction shown by the arrow and
insert a screwdriver at the set hole.
3. Connect the ai ...
Fan switch inspection
1. Remove the climate control unit.
2. Inspect for continuity between the fan switch terminals using an ohmmeter.
If not as specified, replace the fan switch.
...
Other materials:
Mazda 6 Service Manual: Headlight zeroset
Note
When the configuration is not set for the auto leveling control unit,
headlight zeroset cannot be executed.
1. Adjust the tire air pressure to the specification.
2. Position the unloaded vehicle on a flat, level surface.
3. Connect the SST (WDS or equivalent) to the DLC-2.
4. Turn t ...
Mazda 6 Service Manual: Radar Sensors (Rear) (Some models)
Your vehicle is equipped with radar sensors (rear). The following systems also
use the radar sensors (rear).
Blind Spot Monitoring system (BSM)
Rear Cross Traffic Alert (RCTA)
The radar sensors (rear) function by detecting the radio waves reflected off
a vehicle approaching from the rea ...