Mazda 6 Owners Manual: Drive Selection (Some models)
Drive selection is a system to switch the vehicle's drive mode. When the sport mode is selected, vehicle's response against accelerator operation is enhanced. This provides additional quick acceleration which may be needed to safely make maneuvers such as lane changes, merging onto freeways, or passing other vehicles.
CAUTION
Do not use the sport mode when driving on slippery roads such as wet or snow-covered roads. It may cause tire slipping.
NOTE
- When the sport mode is selected, driving at higher engine speeds increases and it may increase fuel consumption. Mazda recommends that you cancel the sport mode on normal driving.
- Drive mode cannot be switched in the following conditions:
- ABS/TCS/DSC is operating
- The Mazda Radar Cruise Control (MRCC) system/cruise control is operating.
- Steering wheel is being operated abruptly
Drive Selection Switch
Press the drive selection switch forward (“
”) to select the sport mode. Pull
the drive selection switch back (“
”) to cancel the sport mode.
NOTE
- When the ignition is switched off, the sport mode is canceled.
- Depending on the driving conditions when sport mode is selected, the vehicle may perform shift-down or slightly accelerate.
Select Mode Indication
When the sport mode is selected, the select mode indication turns on in the instrument cluster.
NOTE
If the drive selection cannot be switched to sport mode, the select mode indication flashes to notify the driver.
Fuel Economy Monitor
The Control Status and Fuel Consumption are switched and displayed by operating
each icon in the display.
In addition, after completing a trip, the total energy efficiency to date is
displayed in ...
Power Steering
Power steering is only operable when the engine is running. If the engine
is off or if the power steering system is inoperable, you can still steer, but
it requires more physical effort. If t ...
Other materials:
Mazda 6 Owners Manual: Torque formulas
When using a torque wrench-SST or equivalent combination, the
written torque must be recalculated due to the extra length that the SST
or equivalent adds to the torque wrench.
Recalculate the torque using the following formulas. Choose the formula that
applies to you.
A : The leng ...
Mazda 6 Owners Manual: Front fog light aiming
1. Adjust the tire air pressure to the specification.
2. Position the unloaded vehicle on a flat, level surface.
3. Seat one person in the drivers seat.
4. Position the vehicle 3 m {10 ft} in front of a white screen.
5. While adjusting one fog light, mask the other.
6. Start the engine to cha ...