Mazda 6 Service Manual: Dtc 18

Dtc 15

Dtc 19

Other materials:

Mazda 6 Service Manual: Thermostat
THERMOSTAT REMOVAL/INSTALLATION 1. Remove the plug hole plate. 2. Disconnect the negative battery cable. 3. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.) 4. Remove the drive belt. (See DRIVE BELT REPLACEMENT.) 5. Remove the washer tank. 6. Remove the P/S oil pump. Note ...

Mazda 6 Service Manual: Combine sensor inspection
Caution Be careful and do not allow the lateral-G sensor to fall. If by chance it is subjected to strong impact, replace it. 1. Connect the connector. 2. Turn ignition switch on, verify the voltage between terminals B and E under the following conditions. If not within the specifi ...