Mazda 6 Service Manual: Dtc p0111

Dtc p0108

Dtc p0112

Other materials:

Mazda 6 Service Manual: Knock sensor inspection
Note Perform the following test only when directed. Resistance Inspection 1. Turn the ignition switch to LOCK. 2. Disconnect the knock sensor connector. 3. Measure the resistance between the knock sensor terminals A and B using an ohmmeter. If not as specified, replace the knock sens ...

Mazda 6 Service Manual: A-pillar trim removal
1. Turn the seaming welt over. 2. Disengage clips A using a fastener remover. 3. Pull the A-pillar trim, then disengage clip B (1). 4. Pull the A-pillar trim upward, then disengage clip B from the A-pillar trim (2). 5. Pull clip B out, then rotate 45°. 6. Remove clip B from the grommet b ...