Mazda 6 Service Manual: Dtc p0134

Dtc p0133

Dtc p0138

Other materials:

Mazda 6 Service Manual: Rear beltline molding removal
Note When removing the rear beltline molding, the clip may be damaged. If the clip is damaged, replace it with a new one. 1. Pull the A section upward and remove the clip. 2. Rotate the B section of the front beltline molding in direction (2), along the direction (1) shown in the figu ...

Mazda 6 Service Manual: Heated oxygen sensor (ho2s) inspection
HO2S Voltage Inspection Note Perform the following inspection only when directed. 1. Warm up the engine and run it at idle. 2. Disconnect the HO2S connector. 3. Connect the voltmeter test leads to the following HO2S terminals: HO2S (front and rear) - (+) leadterminal A - (-) le ...