Mazda 6 Service Manual: Dtc p0480

Dtc p0443

Dtc p0500

Other materials:

Mazda 6 Service Manual: Drive shaft removal/installation
Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropri ...

Mazda 6 Service Manual: Abs (abs/tcs) hu/cm inspection
1. Disconnect the negative battery cable. 2. Connect the SST between the ABS (ABS/TCS) HU/CM and harness connector with the ignition switch off. 3. Attach the tester leads to the SST and inspect voltage referring the table below. Terminal Voltage Table (Reference) (Engine is idling, and co ...