Mazda 6 Service Manual: Dtc p0704

Dtc p0703

Dtc p0850

Other materials:

Mazda 6 Service Manual: Rear beltline molding removal
Note When removing the rear beltline molding, the clip may be damaged. If the clip is damaged, replace it with a new one. 1. Pull the A section upward and remove the clip. 2. Rotate the B section of the front beltline molding in direction (2), along the direction (1) shown in the figu ...

Mazda 6 Service Manual: Condenser removal/installation
4SD 1. Disconnect the negative battery cable. 2. Remove the rear package trim. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. 5HB 1. Disconnect the negative battery cable. 2. Remove the liftgate lower trim. 3. Remove in the order indicated in t ...