Mazda 6 Service Manual: Dtc p0850

Dtc p0704

Dtc p1410

Other materials:

Mazda 6 Service Manual: Electrical troubleshooting tools
Jumper wire A jumper wire is used to create a temporary circuit. Connect the jumper wire between the terminals of a circuit to bypass a switch. Caution Do not connect a jumper wire from the power source line to a body ground. This may cause burning or other damage to wiring harnesse ...

Mazda 6 Service Manual: Side protector removal
1. Pry the side protector end 20-30 mm {0.8-1.1 in} using a flathead screwdriver or a razor. Warning Using a razor with bare hands can cause injury. Always wear gloves when using a razor. Note The side protector is installed with double-sided adhesive tape. If the side protector ...