Mazda 6 Service Manual: Dtc p0712

Dtc p0711

Dtc p0713

Other materials:

Mazda 6 Service Manual: Pcm removal/installation
Note For replace the PCM, Setup the WDS and perform the PCM configuration. (See PCM CONFIGURATION.) 1. Disconnect the negative battery cable. 2. For R.H.D, perform the following procedures. (1) Remove the front side trim (left-side). (2) Partially peel back the flower covering. 3 ...

Mazda 6 Service Manual: Abs (abs/tcs) hu/cm inspection
1. Disconnect the negative battery cable. 2. Connect the SST between the ABS (ABS/TCS) HU/CM and harness connector with the ignition switch off. 3. Attach the tester leads to the SST and inspect voltage referring the table below. Terminal Voltage Table (Reference) (Engine is idling, and co ...