In this section, the basic operation of the voice recognition is explained.
Activating Voice Recognition
Press the talk button.
Ending Voice Recognition
Use one of the following methods:
Skipping Voice Guidance (for faster operation)
Press and release the talk button.
Troubleshooting for Voice Recognition
If you do not understand an operation method while in the voice recognition mode, say “Tutorial” or “Help”.
Commands useable anytime during voice recognition
“Go Back” and “Cancel” are commands which can be used at anytime during voice recognition.
Returning to previous operation
To return to the previous operation, say, “Go Back” while in voice recognition mode.
Cancel
To put the Bluetooth® Hands-Free system in standby mode, say, “Cancel” while in voice recognition mode.
To prevent a deterioration in the voice recognition rate and voice quality, the following points should be observed:
NOTE
If the voice recognition performance is not satisfactory.
Refer to Troubleshooting.
Mazda 6 Owners Manual: Pid/data monitor inspection
1. Connect the WDS or equivalent to the DLC-2.
2. Measure the PID value.
Note
Perform part inspection for the output device after PCM
inspection.
The PID/DATA MONITOR function monitors the calculated value of the
input/output signals in the PCM. Therefore, if a monitored value ...
Mazda 6 Owners Manual: Inspection of dtcs for condition detection mode
Note
The cruise set indicator light will illuminate for 3 seconds,
when condition detection mode is on.
If the RESUME/ACCEL switch on the cruise control switch is
malfunctioning, the cruise set indicator light will not give a correct
indication when you inspect the system.
1. Drive ...