Mazda 6 Service Manual: Dtc p0711

Dtc p0708

Dtc p0712

Other materials:

Mazda 6 Service Manual: Heated oxygen sensor (ho2s) inspection
HO2S Voltage Inspection Note Perform the following inspection only when directed. 1. Warm up the engine and run it at idle. 2. Disconnect the HO2S connector. 3. Connect the voltmeter test leads to the following HO2S terminals: HO2S (front and rear) - (+) leadterminal A - (-) le ...

Mazda 6 Service Manual: Clock spring inspection
1. Remove the clock spring. 2. Inspect for continuity between the clock spring terminals using an ohmmeter. If not as specified, replace the clock spring. Note When the vehicle-side connector of clock spring is disconnected, the terminals 1A,1B, 1C and 1D are shorted to prevent ...