Mazda 6 Service Manual: Dtc p0751

Dtc p0745

Dtc p0752

Other materials:

Mazda 6 Service Manual: Heated oxygen sensor (ho2s) inspection
HO2S Voltage Inspection Note Perform the following inspection only when directed. 1. Warm up the engine and run it at idle. 2. Disconnect the HO2S connector. 3. Connect the voltmeter test leads to the following HO2S terminals: HO2S (front and rear) - (+) leadterminal A - (-) le ...

Mazda 6 Service Manual: Climate control unit inspection
Full-auto Air Conditioner 1. Connect the all center panel connectors. 2. Turn the ignition switch to ON position. 3. Measure the voltage at each climate control unit terminal and refer to the terminal voltage list. If not as specified, inspect the parts listed under Action and the relate ...