Mazda 6 Service Manual: Dtc p0753

Dtc p0752

Dtc p0756

Other materials:

Mazda 6 Service Manual: No.9 tcs off light stays on more than 4 seconds with ignition switch on
When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure connectors, terminals and ...

Mazda 6 Service Manual: Rear beltline molding removal
Note When removing the rear beltline molding, the clip may be damaged. If the clip is damaged, replace it with a new one. 1. Pull the A section upward and remove the clip. 2. Rotate the B section of the front beltline molding in direction (2), along the direction (1) shown in the figu ...