Mazda 6 manuals

Mazda 6 Service Manual: Dtc p0841


Diagnostic procedure



Dtc p0773
Diagnostic procedure ...

Pid/data monitor inspection
  1. Connect the WDS or equivalent to the DLC-2. 2. Measure the PID value. Note Perform part inspection for the output device after PCM inspection. The PID/DATA MONITOR function monit ...

Other materials:

Mazda 6 Service Manual: Wheel hub, hub spindle removal/installation
Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (body side) and fix it to an appropri ...

Mazda 6 Service Manual: Egr valve removal/installation
1. Disconnect the negative battery cable. 2. Disconnect the EGR valve connector. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. Water Hose Removal Note Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT.) EGR Valve Removal Note 1. Re ...

© 2016-2026 Copyright www.mazda6info.net