Mazda 6 Service Manual: Dtc p2006

Dtc p1562

Dtc p2009

Other materials:

Mazda 6 Service Manual: Electrical troubleshooting tools
Jumper wire A jumper wire is used to create a temporary circuit. Connect the jumper wire between the terminals of a circuit to bypass a switch. Caution Do not connect a jumper wire from the power source line to a body ground. This may cause burning or other damage to wiring harnesse ...

Mazda 6 Service Manual: Solenoid valve removal/installation
1. Disconnect the negative battery cable. 2. Remove the under cover. 3. Remove the control valve body. (See CONTROL VALVE BODY REMOVAL.) 4. Remove the solenoid valve(s). 5. Apply ATF to a new O-ring and install it on the solenoid valve. 6. Install the solenoid valve in the control valve body. ...