Mazda 6 Service Manual: Dtc table

After repair procedure

Caution After repairing a malfunction, perform this procedure to verify that the malfunction has been corrected. When this procedure is carried out, be sure to drive the vehicle at lawful speed ...

Dtc p0500

Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: Bonnet switch inspection
Note Bonnet switch has a built-in bonnet lock. 1. Open the bonnet. 2. Disconnect the negative battery cable. 3. Remove the radiator grille. 4. Disconnect the bonnet switch connector. 5. Check the continuity between the bonnet switch terminals A and B using an ohmmeter. If there is ...

Mazda 6 Service Manual: Rear oil seal
REAR OIL SEAL REPLACEMENT 1. Remove the flywheel. (MTX) (See CLUTCH UNIT REMOVAL/INSTALLATION) 2. Remove the drive plate. (ATX) (See DRIVE PLATE REMOVAL/INSTALLATION) 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. Rear Oil Seal Installation Note ...