Mazda 6 manuals

Mazda 6 Service Manual: Engine coolant temperature (ect) sensor removal/installation

Mazda 6 Service Manual / Fuel and emission control systems / Control system / Engine coolant temperature (ect) sensor removal/installation

Warning

1. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.)

2. Disconnect the ECT sensor connector.


3. Remove the ECT sensor.

4. Install in the reverse order of removal.

Tightening torque 10-14 N·m
{1.02-1.42 kgf·m, 7.38-10.32 ft·lbf}

5. Refill the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.)

Manifold absolute pressure (map) sensor inspection
Note Perform the following inspection only when directed. The following vacuum values are indicated by relative pressure from the MAP sensor. 1. Connect the SSTs (WDS or equivalent) to the ...

Engine coolant temperature (ect) sensor inspection
Note Perform the following inspection only when directed. ECT Sensor Resistance Inspection 1. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.) 2. Remove the ECT sensor (locate ...

Other materials:

Mazda 6 Service Manual: Side protector installation
1. Remove the adhesive remaining on the side protector (if it will be reused) and the body using a razor. 2. Remove any grease or dirt from the adhesion surface of the side protector (if it will be reused) and the body. 3. Attach double-sided adhesive tape to the side protector as shown (if it ...

Mazda 6 Service Manual: Warranties for Your Mazda
New Vehicle Limited Warranty Powertrain Limited Warranty Safety Restraint System Limited Warranty Anti-perforation Limited Warranty Federal Emission Control Warranty/California Emission Control Warranty Emission Defect Warranty Emission Performance Warranty Emission Control Warranty ...

© 2016-2026 Copyright www.mazda6info.net