Mazda 6 manuals

Mazda 6 Service Manual: Control system

Three-way catalytic converter (twc) inspection
Note Make sure that no HO2S DTCs have been detected. If detected, this inspection is not applicable for TWC inspection. 1. Connect the WDS or equivalent and monitor PIDs as following. Mo ...

Pcm removal/installation
Note For replace the PCM, Setup the WDS and perform the PCM configuration. (See PCM CONFIGURATION.) 1. Disconnect the negative battery cable. 2. For R.H.D, perform the following procedures. ...

Other materials:

Mazda 6 Service Manual: Vehicle speedometer sensor removal/installation
Without ABS 1. Disconnect the negative battery cable. 2. Remove the battery and battery tray. 3. Remove the air cleaner compornent. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.) 4. Disconnect the vehicle speedometer sensor connector. 5. Remove the vehicle speedometer sensor. 6. Apply transmi ...

Mazda 6 Service Manual: Replacing a Wheel
WARNING Always use wheels of the correct size on your vehicle: Using a wrong-sized wheel is dangerous. Braking and handling could be affected, leading to loss of control and an accident. CAUTION A wrong-sized wheel may adversely affect: Tire fit Wheel and bearing life Ground clearance ...

© 2016-2026 Copyright www.mazda6info.net