Mazda 6 Service Manual: Front tilt motor inspection
1. Disconnect the front tilt motor connector.
2. Inspect the front tilt motor operation when B+ is applied to the terminals as shown.
- If not as specified, replace the seat cushion frame.
Power seat switch inspection
1. Disconnect the power seat switch connector.
2. Disconnect the rear tilt motor connector.
3. Inspect for continuity between the power seat switch connector terminals
using an ohmmeter.
If no ...
Rear tilt motor inspection
1. Disconnect the rear tilt motor connector.
2. Inspect the rear tilt motor operation when B+ is applied to the terminals
as shown.
If not as specified, replace the seat cushion frame.
...
Other materials:
Mazda 6 Service Manual: Vehicle speedometer sensor (vss) inspection
Visual Inspection
1. Remove the VSS. (See VEHICLE SPEEDOMETER SENSOR (VSS)
REMOVAL/INSTALLATION.)
2. Make sure that the sensor is free of any metallic shavings or particles.
If any are found on the sensor, clean them off.
3. Install the VSS. (See VEHICLE SPEEDOMETER SENSOR (VSS)
REMOVAL ...
Mazda 6 Service Manual: Joint shaft disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
Joint Shaft Disassembly Note
Disassemble the joint shaft.
Bearing Disassembly Note
Remove the bearing using the SSTs.
Dust Seal (Right) Assembly Note
1. Apply grease to the new dust se ...