PRECAUTION (SUSPENSION)
Wheels and Tires Removal/Installation
When a wheel is installed, tighten it to 88-118 N·m {9.0-12.0 kgf·m, 65.0-87.0 ft·lbf}.
Suspension Links Removal/Installation
Tighten any part of the suspension that uses rubber bushings only after the vehicle has been lowered and unloaded.
Note
Brake Lines Disconnection/Connection
Caution
1. Tighten the brake pipe flare nut using the SST
(49 0259 770B). Be sure to modify the brake pipe flare nut tightening torque to allow for use of a torque wrench-SST
combination. (See TORQUE FORMULAS.)
2. If any brake line has been disconnected anytime during the procedure, add brake fluid, bleed the brakes, and inspect for leakage after the procedure has been completed.
Power Steering Components Removal/Installation
If any power steering fluid line has been disconnected anytime during the procedure, add ATF M-III
or equivalent (e.g. Dexron®II
), bleed the fluid line, and inspect for leakage after the procedure has been completed.
Wheel alignmentMazda 6 Service Manual: Input/turbine speed sensor inspection
Caution
Water or foreign objects entering the connector can cause a poor
connection or corrosion. Be sure not to drop water or foreign objects on the
connector when disconnecting it.
1. Disconnect the negative battery cable.
2. Remove the battery and battery tray.
3. Remove the air cl ...
Mazda 6 Service Manual: Parking in an Emergency
The hazard warning lights should always be used when you stop on or near a roadway
in an emergency.
The hazard warning lights warn other drivers that your vehicle is a traffic hazard
and that they must take extreme caution when near it.
Depress the hazard warning flasher and all the turn s ...