Mazda 6 Service Manual: Wheel alignment

General procedures

PRECAUTION (SUSPENSION) Wheels and Tires Removal/Installation When a wheel is installed, tighten it to 88-118 N·m {9.0-12.0 kgf·m, 65.0-87.0 ft·lbf}. Suspension Links Removal/Installation Tig ...

Wheel alignment pre-inspection

1. Inspect the tire inflation, and adjust to the recommended pressure as necessary. 2. Inspect the front wheel bearing play and correct it if necessary. (See Wheel Bearing Play Inspection.) 3. I ...

Other materials:

Mazda 6 Service Manual: Woofer inspection
1. Inspect for continuity between the audio amplifier connector terminals and woofer connector terminals using an ohmmeter. If not as specified, replace the related wiring harnesses. 2. Verify that there is battery positive voltage at the woofer connector terminal A (4SD) or C (5HB) u ...

Mazda 6 Service Manual: C-pillar trim removal/installation
4SD 1. Remove the tire house trim. 2. Turn the seaming welt over. 3. Remove the cap using a fastener remover, and remove the bolt (with curtain air bag system). 4. Disengage clips A and clip B using a fastener remover. 5. Pull the C-pillar trim forward, then disengage hook C from the body, ...