Mazda 6 Service Manual: Suspension
- Location index
- General procedures
- Wheel alignment
- Wheel and tire
- Front suspension
- Front shock absorber and spring removal/installation
- Front shock absorber inspection
- Front shock absorber disposal
- Front upper arm removal/installation
- Front upper arm inspection
- Front lower arm (front) removal/installation
- Front lower arm (front) inspection
- Front lower arm (rear) removal/installation
- Front lower arm (rear) inspection
- Front stabilizer removal/installation
- Stabilizer control link inspection
- Front crossmember removal/installation
- Transverse member removal/installation
- Rear suspension
- Rear shock absorber removal/installation
- Rear coil spring removal/installation
- Rear lower arm removal/installation
- Rear upper arm removal/installation
- Rear lateral link removal/installation
- Rear stabilizer removal/installation
- Stabilizer control link inspection
- Trailing link removal/installation
- Rear crossmember removal/installation
No.5 dsc*2 operates frequently/dsc does not work correctly*2: dsc indicator
light goes on and off while dsc operates
Diagnostic procedure
...
Location index
...
Other materials:
Mazda 6 Service Manual: No.7 abs warning light stays on more than 4 seconds with ignition switch on
Diagnostic procedure
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while doing the inspection to discover whether
poor contact points are the cause of any intermittent malfunction. If there is a
problem, check to make sure conne ...
Mazda 6 Service Manual: Steps for Determining the Correct Load Limit
Steps for Determining Correct Load Limit-
1. Locate the statement “The combined weight of occupants and cargo should never
exceed XXX kg or XXX lbs.” on your vehicle's placard.
2. Determine the combined weight of the driver and passengers that will be riding
in your vehicle.
3. Subtract t ...