Mazda 6 manuals

Mazda 6 Service Manual: Rear lower arm removal/installation

Mazda 6 Service Manual / Suspension / Rear suspension / Rear lower arm removal/installation

1. Remove in the order indicated in the table.

2. Install in the reverse order of removal.

3. Inspect the rear wheel alignment. (See REAR WHEEL ALIGNMENT.)



Rear coil spring removal/installation
1. Remove the rear auto leveling sensor. (See REAR AUTO LEVELING SENSOR REMOVAL/INSTALLATION.) 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. 4. Adjust ...

Rear upper arm removal/installation
Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing ...

Other materials:

Mazda 6 Service Manual: Battery Recharging
NOTE Before performing maintenance or recharging the battery, turn off all accessories and stop the engine. To disconnect the battery, remove the negative cable first. Install it last when connecting the battery. Be sure to remove the caps before recharging the battery.   I ...

Mazda 6 Service Manual: Door lock timer unit inspection
1. Measure the voltage at the door lock timer unit terminals (other than terminal 1E and 2W) as indicated below. If not as specified, inspect the parts listed under Action. 2. Disconnect the negative battery cable. 3. Disconnect the door lock timer unit connector and inspect for continuity ...

© 2016-2026 Copyright www.mazda6info.net