Mazda 6 Service Manual: Rear shock absorber removal/installation
Caution
- Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place where the sensor will not be pulled by mistake while servicing the vehicle.
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
Bracket Installation Note
Install the bracket as shown in the figure.
REAR SHOCK ABSORBER INSPECTION
Inspect the rear shock absorber in the same way as the front shock absorber. (See FRONT SHOCK ABSORBER INSPECTION.)
REAR SHOCK ABSORBER DISPOSAL
Dispose the rear shock absorber in the same way as the front shock absorber. (See FRONT SHOCK ABSORBER DISPOSAL.)
Rear suspension
...
Rear coil spring removal/installation
1. Remove the rear auto leveling sensor. (See REAR AUTO LEVELING SENSOR
REMOVAL/INSTALLATION.)
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Adjust ...
Other materials:
Mazda 6 Service Manual: Dsc hu/cm inspection
1. Remove the battery and battery bracket.
2. Disconnect the DSC HU/CM connector.
3. Connect the SST (49 G066 004) to the DSC HU/CM connector and
harness side connector.
4. Inspect voltage referring the table below.
Terminal Voltage Table (reference value)
(Ignition switch is at ON, and conne ...
Mazda 6 Service Manual: Constant Monitoring
The following components of the air bag systems are monitored by a diagnostic
system:
Crash sensors, and diagnostic module (SAS unit),
Front air bag sensors
Air bag modules
Side crash sensors
Air bag/Front seat belt pretensioner system warning light
Front seat belt pretensioners
Re ...