Mazda 6 Service Manual: Front suspension

Wheel and tire

WHEEL BALANCE ADJUSTMENT (16 INCH AND 17 INCH ALUMINUM ALLOY WHEEL) Caution Adjust the outer wheel balance first, then the inner wheel balance. Be careful not to scratch the wheels. Adhes ...

Front shock absorber and spring removal/installation

Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing ...

Other materials:

Mazda 6 Service Manual: Ignition coil inspection
Primary Coil Winding 1. Remove the ignition coil. 2. Measure the resistance between the following lead holes using an ohmmeter. A and B, B and C - If not specified, replace the ignition coil. Specification 0.49-0.57 ohms [20°C {68°F}] Secondary Coil Winding 1. Remove the igni ...

Mazda 6 Service Manual: General procedures
PRECAUTION (FRONT AND REAR AXLE) Wheel and Tire Removal/Installation 1. The removal and installation procedures for the wheels and tires are not mentioned in this section. When a wheel is removed, tighten it to 88-118 N·m {9.0-12.0 kgf·m, 65.0-87.0 ft·lbf} Brake Line Disconnection/Connecti ...