Mazda 6 Service Manual: Dtc table
Note
- Perform the following if the security light stays on:
- If gasoline engine stalls, go to symptom troubleshooting NO.11 ENGINE STALLS/QUITS, ENGINE RUNS ROUGH, MISSES, BUCK/JERK, HESITATION/STUMBLE, SURGES in. (See NO.11 ENGINE STALLS/QUITS, ENGINE RUNS ROUGH, MISSES, BUCK/JERK, HESITATION/STUMBLE, SURGES.)
- If gasoline engine wont start, go to symptom troubleshooting NO.6 CRANKS NORMALLY BUT WILL NOT START in. (See NO.6 CRANKS NORMALLY BUT WILL NOT START.)
- If engine condition is normal but light stays on, inspect for continuity between the following wiring harness and body ground: security light and PCM connector terminal 2W. Repair or replace the wiring harness.
Foreword
Caution
When the engine does not start or stalls and the following DTCs
are not indicated, go to engine symptom troubleshooting.
Note
When the immobilizer system is defective, the engine ...
Dtc b1681
Diagnostic procedure
...
Other materials:
Mazda 6 Service Manual: Glass panel adjustment
1. Fully close the glass panel.
2. Measure the gap and height between the glass panel and body.
3. If not as specified, loosen the glass panel installation screws and
reposition the glass panel.
Clearance
a: -0.8-1.2 mm {-0.032-0.047 in}
b: 0 mm {0 in}
4. Tighten the installation scre ...
Mazda 6 Service Manual: Windshield wiper motor removal/installation
1. Disconnect the negative battery cable.
2. Remove the windshield wiper arm and blade. (See WINDSHIELD WIPER ARM AND
BLADE REMOVAL/INSTALLATION.)
3. Remove the cowl grille. (See COWL GRILLE REMOVAL/INSTALLATION.)
4. Remove in the order indicated in the table.
5. Install in the reverse ord ...