Mazda 6 Service Manual: Glass panel removal/installation
1. Fully close the glass panel.
2. Fully open the sunshade.
3. Remove the screws, and then remove the glass panel.
4. Peel the weatherstrip off the glass panel.
5. Install in the reverse order of removal.
6. Adjust the glass panel. (See GLASS PANEL ADJUSTMENT.)
Deflector removal/installation
1. Fully open the glass panel.
2. Remove the headliner.
3. Remove the screws.
4. Disengage the hooks.
(1) Press the rear end of each hook.
(2) After sliding the hooks rearward, press them upw ...
Glass panel adjustment
1. Fully close the glass panel.
2. Measure the gap and height between the glass panel and body.
3. If not as specified, loosen the glass panel installation screws and
reposition the glass panel.
...
Other materials:
Mazda 6 Service Manual: Purge solenoid valve inspection
Airflow Inspection
Note
Perform the following test only when directed.
1. Disconnect the negative battery cable.
2. Remove the purge solenoid valve. (See PURGE SOLENOID VALVE
REMOVAL/INSTALLATION.)
3. Inspect airflow between the ports under the following conditions.
If not as specifi ...
Mazda 6 Service Manual: Key Battery Replacement
If the buttons on the transmitter are inoperable and the operation indicator
light does not flash, the battery may be dead.
Replace with a new battery before the transmitter becomes unusable.
CAUTION
Make sure the battery is installed correctly. Battery leakage could occur
if it is not in ...