Mazda 6 Service Manual: Glass panel adjustment
1. Fully close the glass panel.
2. Measure the gap and height between the glass panel and body.
3. If not as specified, loosen the glass panel installation screws and reposition the glass panel.
Clearance
a: -0.8-1.2 mm {-0.032-0.047 in} b: 0 mm {0 in}
4. Tighten the installation screws.
5. Insert a prepaid card between the weatherstrip and the body of the vehicle. Verify that the sunroof is shut tightly (there is resistance when the prepaid card is moved).
- If the sunroof is not shut tightly, readjust by performing Steps 3 and 4.
Glass panel removal/installation
1. Fully close the glass panel.
2. Fully open the sunshade.
3. Remove the screws, and then remove the glass panel.
4. Peel the weatherstrip off the glass panel.
5. Install in the reverse order ...
Front drain hose removal
1. Remove the headliner.
2. Disconnect the front drain hose from the sunroof frame.
3. Remove the front drain hose from the clips.
4. Pull the front drain hose into the room side.
5. Remove the fr ...
Other materials:
Mazda 6 Service Manual: Inboard combination light removal/installation
1. Disconnect the negative battery cable.
2. Remove the trunk lid trim (liftgate lower trim). (See TRUNK LID TRIM
REMOVAL/INSTALLATION) (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Inboard Combinat ...
Mazda 6 Service Manual: Bonnet adjustment
Gap Adjustment
1. Remove the front fender.
2. Loosen the bonnet hinge installation bolts and reposition the bonnet.
3. Tighten the bolts.
4. Verify that the gap between the bonnet and the body is within the
specification.
Clearance
a: 2.5-4.5 mm {0.08-0.17 in}
Height Adjustment
1 ...