Mazda 6 Service Manual: Jacking positions ,vehicle lift (2 supports),safety stands (rigid rack) positions
Jacking Positions
Warning
- Improperly jacking a vehicle is dangerous. The vehicle can slip off the jack and cause serious injury. Use only the correct front and rear jacking points and block the wheels.
- Use safety stands to support the vehicle after it has been lifted.
Front
- At the jacking plate of the engine support member.
Rear
- At the center of torsion beam axle.
Vehicle Lift Positions
Front and rear
Warning
- Unstably lifting a vehicle is dangerous. The vehicle can slip off the lift and cause serious injury and/or vehicle damage. Make sure that the vehicle is on the lift horizontally by adjusting the height of support at the end of the arm of the lift.
Safety Stand Positions
Front
- Both sides of the vehicle, on side sills.
Rear
- Both sides of the vehicle, on side sills.
Jacking positions, vehicle lift (2 supports) and safety stand (rigid rack) positions view
Precautions before welding
Vehicles have various electrical parts. To protect the parts from excessive
current generated when welding, be sure to perform the following procedure.
1. Turn the ignition switch to the LOCK posit ...
Towing
...
Other materials:
Mazda 6 Service Manual: Front seat removal/installation
Warning
Handling the front seat (side air bag) improperly can accidentally
deploy the side air bag, which may seriously injure you. Read AIR BAG SYSTEM
SERVICE WARNINGS before handling the front seat. (See SERVICE WARNINGS.)
1. Turn the ignition switch to the LOCK position.
2. Disconne ...
Mazda 6 Service Manual: Dsc hu/cm inspection
1. Remove the battery and battery bracket.
2. Disconnect the DSC HU/CM connector.
3. Connect the SST (49 G066 004) to the DSC HU/CM connector and
harness side connector.
4. Inspect voltage referring the table below.
Terminal Voltage Table (reference value)
(Ignition switch is at ON, and conne ...