Mazda 6 Service Manual: No.2 air bag system warning light is illuminated all the time

Mazda 6 Service Manual / Body electrical system / Troubleshooting / No.2 air bag system warning light is illuminated all the time

Diagnostic Procedure

When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure connectors, terminals and wiring harness are connected correctly and undamaged.

No.1 air bag system warning light does not illuminate

Diagnostic Procedure When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact point ...

No.3 passenger-side air bag cut-off indicator light does not illuminate

Diagnostic Procedure When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact point ...

Other materials:

Mazda 6 Service Manual: Oil pressure switch removal/installation
Warning When the transaxle and ATF are hot, they can badly burn. Turn off the engine and wait untill they are cool before replacing ATF. 1. Disconnect the negative battery cable. 2. Remove the under cover. 3. Disconnect the cord assembly connector. 4. Remove the oil pressure switch. ...

Mazda 6 Service Manual: Setting the System
When the MODE switch is pressed, the Mazda Radar Cruise Control (MRCC) main indication (white) turns on and the vehicle speed and the distance between vehicles while in headway control can be set. NOTE When the ignition is switched to ACC or OFF while the Mazda Radar Cruise Control (MR ...