Mazda 6 manuals

Mazda 6 Service Manual: No.3 amount of air blown from vents does not change

Mazda 6 Service Manual / Heater and air conditioner systems / Troubleshooting / No.3 amount of air blown from vents does not change

Manual Air Conditioner


Diagnostic procedure



No.2 amount of air blown from vents does not change
Full-auto Air Conditioner When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while performing the inspection to discover whether poor c ...

No.4 air intake mode does not change
When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while performing the inspection to discover whether poor contact points are the cause ...

Other materials:

Mazda 6 Service Manual: Manifold absolute pressure (map) sensor inspection
Note Perform the following inspection only when directed. The following vacuum values are indicated by relative pressure from the MAP sensor. 1. Connect the SSTs (WDS or equivalent) to the DLC-2. 2. Turn the ignition switch to ON (Engine OFF). 3. Select MAP PID on the SSTs (WDS or equi ...

Mazda 6 Service Manual: Discharge headlight control unit removal/installation
Caution Incorrect servicing of the discharge headlight control unit could result in electrical shock. Before servicing the discharge headlight control unit, always refer to the Discharge headlight service warnings. (See DISCHARGE HEADLIGHT SERVICE WARNINGS) When replacing the discharg ...

© 2016-2026 Copyright www.mazda6info.net