Mazda 6 manuals

Mazda 6 Service Manual: No.2 amount of air blown from vents does not change

Mazda 6 Service Manual / Heater and air conditioner systems / Troubleshooting / No.2 amount of air blown from vents does not change

Full-auto Air Conditioner


Diagnostic procedure




No.1 insufficient air (or no air) blown from vents
Diagnostic Procedure ...

No.3 amount of air blown from vents does not change
Manual Air Conditioner Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: Sunroof relay inspection
Note Sunroof relay is built in the sunroof motor. 1. Remove the headliner. (See HEADLINER REMOVAL/INSTALLATION.) 2. Connect the sunroof switch connector. 3. Measure the voltage at the sunroof relay terminals as indicated below. 4. Disconnect the sunroof relay connector before inspecting fo ...

Mazda 6 Service Manual: Dtc b1318
Caution When attaching the tester lead to the ABS (ABS/TCS) HU/CM harness connector, the SST (49 G066 001) must be used. (See ABS (ABS/TCS) HU/CM INSPECTION.) Diagnostic procedure ...

© 2016-2026 Copyright www.mazda6info.net