Mazda 6 manuals

Mazda 6 Service Manual: Oil pressure switch inspection

1. Verify that the oil pressure warning light illuminates when the ignition switch is at ON position.

2. Verify that the oil pressure warning light goes off when the engine is started.

- If the related wiring harness are normal, inspect the oil pressure. (See OIL PRESSURE INSPECTION.)

  • If the oil pressure is normal, replace the oil pressure switch.
Fuel gauge sender unit inspection
Move the float to the topmost and bottommost positions, and verify that the resistance between terminals A and B of the unit and the position of the float are as indicated in the figure. If th ...

Horn removal/installation
1. Disconnect the negative battery cable. 2. Bend the mud guard. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. ...

Other materials:

Mazda 6 Service Manual: Running light unit inspection
1. Connect the connector to the running light unit. 2. Connect the negative battery cable. 3. Measure the voltage at the running light unit using voltmeter. When inspecting terminal D, H or P for continuity, disconnect the running light unit connector. 4. If the value are not as specif ...

Mazda 6 Service Manual: Fuel-Filler Cap
To remove the fuel-filler cap, turn it counterclockwise. Attach the removed cap to the inner side of the fuel lid. To close the fuel-filler cap, turn it clockwise until a click is heard. CAUTION (U.S.A. and Canada) If the check fuel cap warning light illuminates, the fuel-filler cap may not ...

© 2016-2026 Copyright www.mazda6info.net