Mazda 6 Owners Manual: Operation of Automatic Air-conditioning
1. Press the AUTO switch. Selection of the airflow mode, air intake selector and amount of airflow will be automatically controlled.
2. Use the temperature control dial to select a desired temperature. Press the DUAL switch or turn the front passenger temperature control dial to control the set temperature individually for the driver and front passenger.
To turn off the system, press the OFF switch.
NOTE
- Setting the temperature to maximum hot or cold will not provide the desired temperature at a faster rate.
- When selecting heat, the system will restrict airflow until it has warmed to prevent cold air from blowing out of the vents.
Control Switches
AUTO switch
By pressing the AUTO switch the following functions will be automatically controlled
in accordance with the selected set temperature:
Airflow temperature
Amount of airflow
Selec ...
Windshield Defrosting and Defogging
Press the windshield defroster switch. In this position, the outside air position
is automatically selected, and the air conditioner automatically turns on. The air
conditioner will directly dehum ...
Other materials:
Mazda 6 Owners Manual: Foreword
Caution
When the engine does not start or stalls and the following DTCs
are not indicated, go to engine symptom troubleshooting.
Note
When the immobilizer system is defective, the engine cannot be
started.
If engine condition is normal but light stays on, inspect for
short circ ...
Mazda 6 Owners Manual: Drive shaft removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing the following procedures, remove the
ABS wheel-speed sensor (axle side) and fix it to an appropri ...