Mazda 6 manuals

Mazda 6 Service Manual: Rear combination light removal/installation

Mazda 6 Service Manual / Body electrical system / Exterior lighting system / Rear combination light removal/installation

1. Disconnect the negative battery cable.

2. Remove the trunk side trim. (See TRUNK SIDE TRIM REMOVAL/INSTALLATION)

3. Remove in the order indicated in the table.



4. Install in the reverse order of removal.

Front fog light bulb removal/installation
1. Disconnect the negative battery cable. 2. Remove in the order indicated in the table. Caution A halogen bulb generates extremely high heat when it is used. If the surface of the bulb i ...

Inboard combination light removal/installation
1. Disconnect the negative battery cable. 2. Remove the trunk lid trim (liftgate lower trim). (See TRUNK LID TRIM REMOVAL/INSTALLATION) (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION) 3. Remove in ...

Other materials:

Mazda 6 Service Manual: Pcm inspection
Note PIDs for the following parts are not available on this model. Go to the appropriate part inspection page. - CMP sensor (See CAMSHAFT POSITION (CMP) SENSOR INSPECTION.) - Main relay (See RELAY INSPECTION.) 1. Connect the SST (WDS or equivalent) to the DLC-2. 2. Turn the igni ...

Mazda 6 Service Manual: Dsc on-board diagnosis
On-Board Diagnostic (OBD) Test Description (See ABS (ABS/TCS) ON-BOARD DIAGNOSIS) DTC Table PID/DATA Monitor Table Active Command Modes Table ...

© 2016-2026 Copyright www.mazda6info.net