Mazda 6 Service Manual: Rearview mirror installation
Install the rearview mirror onto the base.
Rearview mirror removal
1. Insert a screwdriver between the mirror and the base.
2. Push the base pin down to remove the rearview mirror. ...
Base removal
1. Remove the rearview mirror.
2. Wind each end of a wire around a bar.
Warning
Using a SST (piano wire) with bare hands can cause injury. Always
wear gloves when using a SST (piano wire).
...
Other materials:
Mazda 6 Service Manual: Engine control system operation inspection
Main Relay Operation Inspection
Verify that the main relay clicks when the ignition switch is turned to ON
position and off.
If there is no operation sound, inspect the following.
- Main relay (See RELAY INSPECTION.)
- Harness and connector between ignition switch and main relay termi ...
Mazda 6 Service Manual: General procedures
PRECAUTION (SUSPENSION)
Wheels and Tires Removal/Installation
When a wheel is installed, tighten it to 88-118 N·m {9.0-12.0 kgf·m,
65.0-87.0 ft·lbf}.
Suspension Links Removal/Installation
Tighten any part of the suspension that uses rubber bushings only after the
vehicle has been lowered ...