Mazda 6 manuals

Mazda 6 Service Manual: Shroud panel removal/installation

Mazda 6 Service Manual / Body / Body shell / Shroud panel removal/installation

1. Remove the bonnet. (See BONNET REMOVAL/INSTALLATION.)

2. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION.)

3. Remove the front combination light. (See FRONT COMBINATION LIGHT REMOVAL/INSTALLATION.)

4. Remove the front bumper reinforcement. (See BUMPER REINFORCEMENT REMOVAL/INSTALLATION.)

5. Remove in the order indicated in the table.



6. Install in the reverse order of removal.

Body shell
...

Cowl panel removal/installation
1. Remove the windshield wiper arm and blade. (See WINDSHIELD WIPER ARM AND BLADE REMOVAL/INSTALLATION.) 2. Remove the cowl grille. 3. Remove the windshield wiper motor. (See WINDSHIELD WIPER MOTO ...

Other materials:

Mazda 6 Service Manual: Electrical parts
Battery cable Before disconnecting connectors or removing electrical parts, disconnect the negative battery cable. Wiring Harness To remove the wiring harness from the clip in the engine room, pry up the hook of the clip using a flathead screwdriver. ...

Mazda 6 Service Manual: Drive shaft (atx) disassembly/assembly
1. Disassemble in the order indicated in the table. 2. Assemble in the reverse order of disassembly. Boot Band (Wheel Side) Disassembly Note Note The boot band does not need to be removed unless it is being replaced. Remove the boot clamp with end clamp pliers as shown and discard the cla ...

© 2016-2026 Copyright www.mazda6info.net