Warning
Warning
1. Remove in the order indicated in the table.


2. Install in the reverse order of removal.
3. Turn the ignition switch to ON position.
4. Verify that the air bag system warning light illuminates for approximately 6 seconds
and then goes off.
Connector Removal Note
1. Using a flathead screwdriver, pry out the connector's stopper plate.

2. Disconnect the connector.
Passenger-side air bag module removal/installation
Curtain air bag module removal/installationMazda 6 Service Manual: Wheel alignment pre-inspection
1. Inspect the tire inflation, and adjust to the recommended pressure as
necessary.
2. Inspect the front wheel bearing play and correct it if necessary. (See
Wheel Bearing Play Inspection.)
3. Inspect the wheel and tire runouts. (See SUSPENSION.)
4. Inspect the ball joints and steering linkag ...
Mazda 6 Service Manual: Fuel tank inspection
Caution
Disconnecting/connecting the quick release connector without
cleaning it may possibly cause damage to the fuel pipe and quick release
connector. Always clean the quick release connector joint area before
disconnecting/connecting using a cloth or soft brush, and make sure that it ...