Mazda 6 Service Manual: Side panel removal/installation
1. Disengage clips using a tape-wrapped flathead screwdriver.
2. Pull the side panel toward you, then disengage tabs from dashboard, and remove the side panel.
3. Install in the reverse order of removal.
Dashboard disassembly/assembly
1. Remove the passenger-side air bag module.
2. Remove the ventilator grilles.
3. Remove the audio unit.
4. Remove the climate control unit.
5. Disassemble in the order indicated in the table.
6. ...
Column cover removal/installation
1. Detach the fit of the upper column cover from the meter hood rubber.
2. Remove the upper column cover.
3. Remove the ignition key illumination.
4. Remove the screws.
5. Remove the lower colum ...
Other materials:
Mazda 6 Service Manual: Electrical parts
Battery cable
Before disconnecting connectors or removing electrical parts, disconnect
the negative battery cable.
Wiring Harness
To remove the wiring harness from the clip in the
engine room, pry up the hook of the clip using a
flathead screwdriver.
...
Mazda 6 Service Manual: Oil cooler
LF, L3
1. Remove the under cover.
2. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT.)
3. Remove the oil filter cover, and drain the engine oil into a container.
(See OIL FILTER REPLACEMENT.)
4. Remove in the order indicated in the table.
5. Use a clean rag to wipe off the m ...