Mazda 6 manuals

Mazda 6 Service Manual: Special service tools


Preparation of tools and measuring equipment
Be sure that all necessary tools and measuring equipment are available before starting any work. ...

Oil leakage inspection
Use either of the following procedures to identify the type of oil that is leaking: Using UV Light (Black Light) 1. Remove on the engine or transaxle. Note Referring to the fluorescent ...

Other materials:

Mazda 6 Service Manual: Dsc hu/cm removal/installation
Caution When replacing the DSC HU/CM, configuration procedure must be done before removing the DSC HU/CM. If configuration is not completed before removing the DSC HU/CM, DTC B2477 will be detected. Do not drop the DSC HU/CM. Replace it if it is subjected to an impact. 1. Configura ...

Mazda 6 Service Manual: Electrical troubleshooting tools
Jumper wire A jumper wire is used to create a temporary circuit. Connect the jumper wire between the terminals of a circuit to bypass a switch. Caution Do not connect a jumper wire from the power source line to a body ground. This may cause burning or other damage to wiring harnesse ...

© 2016-2026 Copyright www.mazda6info.net